Yaskawa Ladder Works Programming Manual - Manual (Page 17)

1.11 RESET COIL Instructions (R-COIL)
1-12
1.11 RESET COIL Instruction (R-COIL)
[Outline]
The R-COIL turns OFF the output when the execution condition is satisfied, and maintains the OFF
state.
[Format]
Symbol : R-Coil
Full Name : Reset Coil
Category : RELAY
Icon :
[Parameter]
Parameter Name Setting
Coil No. · Any bit type register (except for # and C register)
· Any bit type register with subscript (except for # and C registers)
[Program Example]
Case where the same output destination is designated multiple times.
The above example acts as in the graph below.
* When OB00000 is ON,
with the "reset coil"
instruction, OB00000
turns OFF.
*
MB000000
MB000001
MB000002
MB000003
OB00000