Linkskey LKV-IPM01 - Manual (Page 18)

KLE User Guide R1.2
KLE supports most display modes up to 1280 x 1024. However, you might encounter some display
problems when your display card is outputting an unusual display mode. These possible problems are either
no video or abnormal display on viewer screen.
To simplify the display factor before connection to KLE, we suggest you use more standard display modes
such as: 800 x 600 @ 72Hz/75Hz, 1024 x 768 @ 72Hz/75Hz, etc. For the suggested display modes, please
refer to the following table.
640 x 400 640 x 480 800 x 600
1024 x
768
1152 x
864
1280 x
1024
56Hz
60Hz D D D D D
61Hz
64Hz
70Hz D D D
72Hz D D
74Hz
75Hz D D D
76Hz D
78Hz D
84Hz
85Hz D D D D
100Hz D D D
Note: These are suggested display modes for server desktop connected KLE. However, the actual feasible display
modes for as specific server desktop will be dependent on its display card. Some display modes listed here might not be
feasible with some display card. Try to do some trials to determine the best display mode for your desktop on KLE
viewer.
Disable special transition effects on the screen outputs of your connected servers
Go to Control Panel/ Display / Appearance / Effects. And then uncheck the option to disable transition
effects such as Fade for the menus and tool tips. You should perform the same check on each of your
connected servers.
On Windows platforms such as Windows 98, 2000, XP and 2003 Server, some transition effects might
yield undesirable video refreshing artifacts, especially when you are using Medium or Low Video Quality as
your video filter settings. To avoid undesirable artifacts from appearing on your screen, please turn off the
special transition effects.
- - 14