Linkskey LKV-IPM01 - Manual (Page 59)

KLE User Guide R1.2
Do not generate alarm : If you do not want the scanning process to generate alarm
or SNMP messages for this computer then you should check this option to exclude it.
Power Management
Power Down Command : Specifies the power down command sent over the serial
control port for the additional remote power control unit you connect to the serial
control port of KLE, e.g. “/F016\” to power down power bank 01 port 6 with the
cascadable power control module such as the ioPower; “/F000\” to power off all
ports on all bank. To send the power down command to a specific port over the
viewer, just switch to that port and evoke the viewer Quick Menu to click Power off
Delay (sec.): Specify the delay time between the sending of power down commands
and that of the power on command, when the Restart Computer option is enabled
and KLE receiving a specified alarm (either No Video, Blue Screen, NumLock Test
failure). For more details, please refer to the Section 4.10, Alarms – e-mail
Notifications and SNMP Logging Support for Server Alerting Events. The delay time
between the power off and the power on command is default to 5 seconds.
Power On Command : specifies the power on command sent over the serial control
port for the additional remote power control unit you connect to the serial control
port on the backpanel of KLE,, e.g. “/O016\” to power on power bank 01 port 6 with
the cascadable power control module such as the ioPower; “/O000\” to power on all
ports on all bank. To send the power on command to a specific port over the viewer,
just switch to that port and evoke the viewer Quick Menu to click Power on
When using a remote power control device for power control of your connected server, please note that
some newer motherboard form factors, such as ATX, etc, will require BIOS option adjustment to respond to
the resumed power feed from its power bus by your power control device. Usually, you should enable the
Power Loss Restart option on your Motherboard BIOS (or similar option depending on your BIOS vendor),
so that your connected servers can boot up when your power control device is feeding power to its power bus.
- - 55