Precision Digital PD650 - Manual (Page 16)

Model PD650 Large Display Process Meter Instruction Manual
16
Display
Parameter Description/Comments
LInear Linear input Indicates linear input was selected.
min Minute Sets time base to display rate in units per minute.
No PtS Number of points Sets meter for 2 to 11 calibration points.
OFFSET Preset offset Sets preset offset value (Relay n trips at a point below
Relay n+1 preset value).
outPut Output Sets the optional 4-20 mA output values.
Pro9 r Programmable root Sets exponent for special root extraction used for weirs
and flumes.
R or t Rate or total Sets set points for process/rate or total.
Rate Rate Indicates set point was assigned to rate.
Rset P Reset peak Erases peak value from memory and captures a new
peak reading.
RSEt t Reset total Resets the totalizer to zero.
SCALE Scale
Scales meter using internal calibration for desired display
(Signal source not required).
SeC Second
Sets time base to display rate in units per second.
SEt 1 Set point 1
Sets operation for set point 1.
SEt 2 Set point 2
Sets operation for set point 2.
SEt 3 Set point 3
Sets operation for set point 3.
SEt 4 Set point 4
Sets operation for set point 4.
SetPtS Set points
Sets alarm set /reset points and total presets (relays are
optional).
Setup Setup
Sets operation of set points for process/rate or total,
latching or non-latching, etc.
SquArE Square root
Sets meter for square root extraction.
t bASE Time base
Sets meter with correct time unit factor (second, minute,
hour, or day).
Tot CF Totalizer conversion
factor
Sets multiplier factor to display total in any engineering
unit.
Tot dp Total decimal point
Sets the decimal position for the totalizer.
TotAL Total
Indicates set point was assigned to total.
y or n Yes or no
Sets selection or de-selection of various functions.