Precision Digital PD650 - Manual (Page 52)

Model PD650 Large Display Process Meter Instruction Manual
52
Select total when the first set point was assigned to
total
After selecting t for total for second set point, the display will
show preset offset (OFFSEt) press ENTER to set up this
function. If ENTER is not pressed within 3 seconds, this
function will remain programmed as it was before, and the
next set point will be displayed.
R or t
then
OFFSET
then
SEt 3
If ENTER is pressed while the display reads
OFFSET, yes or no (Y or N) will flash alternately. To
program this set point for preset offset, press
ENTER when Y is flashing. To program this set
point without preset offset, press ENTER when n
is flashing. After making the selection, setup of set
point 2 is complete and the next set point will be
displayed. Press ENTER to set up that set point, if
not, wait until desired set point is displayed or wait
for the meter to exit the Setup menu completely.
OFFSET
then
Y or n
then
SEt 3
Setup of the remaining set points
The remaining set points, set point 3 and set point 4 are set up in the same
fashion as set point 2. They can be set up as process/rate or total set points.
Programming Internal Total Reset and Delay (DELAy)
Select internal total reset and programmable delay
The entire display will flash for three seconds. For
instructions see Five Basic Digit/Display Setting
Instructions, page 30. .
This completes the delay on release programming.
I or e
Delay
then
000010
final delay
000600
The display moves to setting the relays for pump alternation control.