TA Triumph-Adler DC 2116 - Manual (Page 108)

System Settings
3-26 ADVANCED OPERATION GUIDE
Auto Sleep
Use to set the machine to enter sleep mode automatically when a preset
period of time of non-use elapses.
NOTE: This setting is displayed only on the inch specification machine.
If the Auto Sleep function causes inconvenience, it is recommended to try
a longer time period before disabling the function. If you disable this
function, it is not displayed.
1 Display the Machine default screen, refer to Access the Machine Default
Screen, on page 3-15.
2 Press
S or T to select Auto
Sleep and press [Enter].
3 Press
S or T to select On or Off
and press [Enter].
4 Press [Reset]. The Copier Basic screen returns.
Auto Clear
Using Auto Clear, once a specified amount of time has passed after
copying stops (between 10 and 270 seconds), the machine returns to the
current default settings. Copies can be made continually using the same
settings (e.g. copy mode, number of copies, and exposure mode) if each
job is started before the Auto Clear function is activated.
1 Display the Machine default screen, refer to Access the Machine Default
Screen, on page 3-15.
2 Press S or T to select Auto Clear
and press [Enter].
3 Press S or T to select On or Off
and press [Enter].
4 Press [Reset]. The Copier Basic screen returns.
On :
:
Auto Sleep
Machine Default:
PIN # Change
Display Contrast
Auto Sleep:
Off
On *
On :
On : Auto Clear
Auto Sleep
Machine Default:
PIN # Change
Auto Clear:
Off
On *