TA Triumph-Adler DC 2116 - Manual (Page 135)

Appendix
ADVANCED OPERATION GUIDE Appendix-3
Selecting the Right Paper
This section describes the guidelines for selecting paper.
Condition
Avoid using paper that is bent at the edges, curled, dirty, torn, embossed,
or contaminated with lint, clay, or paper shreds.
Use of paper in these conditions can lead to illegible printing and paper
jams, and can shorten the life of the machine. In particular, avoid using
paper with a surface coating or other surface treatment. Paper should have
as smooth and even a surface as possible.
Composition
Do not use paper that has been coated or surface-treated and contains
plastic or carbon. The heat of fusing can cause such paper to give off
harmful fumes.
Bond paper should contain at least 80 % pulp. Not more than 20 % of the
total paper content should consist of cotton or other fibers.
Paper Sizes
Cassettes and the Multi-Bypass Tray are available for the paper sizes
listed in the table below. The dimensional tolerances are ±0.7 mm
(±0.0276 inches) for the length and width. The angle at the corners must
be 90° ±0.2°.
Thickness 0.086 to 0.110 mm (3.4 to 4.3 mils)
Dimensional accuracy ±0.7 mm (±0.0276 inches)
Squareness of corners 90° ±0.2°
Moisture content 4 % to 6 %
Direction of grain Long grain
Pulp content 80 % or more
Item Specification
Multi-Bypass Tray Cassette or Multi-Bypass Tray
B6R (128 × 182 mm) A3 (297 × 420 mm)
A6R (105 × 148 mm) B4 (257 × 364 mm)
Postcard (100 × 148 mm) A4 (297 × 210 mm)
Return postcard (148 × 200 mm) A4R (210 × 297 mm)
Executive (7 1/4 × 10 1/2 ") B5 (257 × 182 mm)