TA Triumph-Adler DC 2116 - Manual (Page 79)

Printer Settings
ADVANCED OPERATION GUIDE 2-51
Auto Continue
If any of the following error messages appear, the error can be cleared and
printing can be continued after the preset recovery time elapses (auto
continue).
• Memory Overflow
• Print overrun
• KPDL error
• File not found
• HARD DISK error
• RAM disk error
• MemoryCard err
• Illegal Account
• Exceeded Max.out
• Account error
• Duplex disabled
• Add Staples
• e-MPS not stored
• Opt. ROM error
You can also set the time that elapses before Auto Continue is activated.
1 Display the Others screen, refer to Access the Others Screen, on page 2-
48.
2 Press S or T to select Auto
Continue and press [Enter].
3 Press S or T to select On or Off
and press [Enter]. If you have
selected On, Change # displays.
4 To set the time that elapses
before Auto Continue is activated,
press
S or T to select Change #
and press [Enter].
The Auto Continue (time) screen displays.
5 Press < or > to select the time, 0
to 495 seconds in 5 second
increments can be selected.
Press [Enter].
6 Press [Reset]. The Printer Basic screen displays.
Auto Continue
Resource Prot.
Others
Printer Reset
Back
On
Auto Continue
Off
Change #
On
Auto Continue
Off
(0
Auto Continue (Time)
30 495) sec.