TA Triumph-Adler DC 2116 - Manual (Page 40)

Printer Settings
2-12 ADVANCED OPERATION GUIDE
NOTE: Use a parallel interface cable that complies with the IEEE 1284
standard.
1 Display the Interface screen, refer to Access the Interface Screen, on page
2-11.
2 Press S or T to select Parallel
and press [Enter].
3 Press S or T to select the
transmission/reception mode
required and press [Enter].
4 Press [Reset]. The Printer Basic screen displays.
Network Setting
To perform network printing, network setup is required. This section
describes the tasks required for using the network function.
NOTE: Before setting the IP Address, ask your Network Administrator to
obtain the address and prepare it.
NetWare
Set this option to On if connecting to a NetWare network.
1 Display the Interface screen, refer to Access the Interface Screen, on page
2-11.
2 Press S or T to select Network
and press [Enter].
3 Press
S or T to select NetWare
and press [Enter].
Nibble (high) High speed data communication is used in compliance with
the IEEE 1284 standard.
Mode Description
Back
Parallel
Interface
Network
Back
Auto
Parallel
Normal
Back
Parallel
Interface
Network
Back
NetWare
Network Setting
TCP/IP