TA Triumph-Adler DC 2435 - Manual (Page 326)

Default Setting (System Menu)
9-28
Repeat Copy
Select the Repeat Copy default. The options are as follows. The table below shows the available settings.
NOTE: This setting is not displayed when the optional Data Security Kit is installed or the Repeat Copy job is
set to 0.
Refer to page 4-43 for Repeat Copy.
Use the procedure below to set the default Repeat Copy setting.
1 Press the System Menu key.
2 Press [Common Settings], [ ] and [Next] of Function Defaults. Press [ ] three times and [Change] of
Repeat Copy.
3 Select the default for [Off] or [On].
4 Press [OK].
DP Read Action
Set the operation when a document is scanned from the document processor. The table below shows the
available settings.
NOTE: The optional document processor is required.
Cannot be used when set to [On] in Document Guard on page 9-108.
Use the procedure below to set a DP Read Action.
1 Press the System Menu key.
2 Press [Common Settings], [ ] and [Next] of Function Defaults. Press [ ] three times and [Change] of DP
Read Action.
3 Select [Speed Priority] or [Quality Priority].
4 Press [OK].
Item Description
Off No Repeat Copy is performed.
On Repeat Copy is performed.
Item Description
Speed Priority Priority given to scanning speed.
Quality Priority Priority given to image quality.