TA Triumph-Adler DC 2435 - Manual (Page 372)

Default Setting (System Menu)
9-74
Calibration Cycle
After Auto Clear has been activated, or during printing, Calibration... Remaining: 50 seconds may be displayed.
While this message is displayed, the machine makes adjustments to maintain image quality. Wait until the
message disappears.
Set the calibration cycle here. The setting items are as follows.
1 Press the System Menu key.
2 Press [ ], [Adjustment/Maintenance], [ ] and then [Change] of Calibration Cycle.
3 Select [Auto], [Short], [Standard] or [Long].
4 Press [OK].
Calibration
Calibrate the device to ensure consistency with the original grayscale. If you find that the grayscale is not
improved by this calibration, use tone curve adjustment (see page 9-71).
1 Press the System Menu key.
2 Press [ ], [Adjustment/Maintenance], [ ] and then [Next] of Calibration.
3 Press [Execute]. Calibration begins.
4 Press [OK] after Calibration is complete.
Item Description
Auto Automatically sets the cycle for calibration.
Short Sets a short calibration cycle and increases the number of times
performed, with priority to image quality.
Standard Sets a standard calibration cycle, compromising between image
quality and downtime for processing.
Long Sets a long calibration cycle and decreases the number of times
performed, to ensure minimal downtime.