TA Triumph-Adler DC 2435 - Manual (Page 369)

Default Setting (System Menu)
9-71
9
Display Brightness
Set the brightness of the touch panel.
Use the procedure below to adjust the display brightness.
1 Press the System Menu key.
2 Press [ ], [Adjustment/Maintenance] and then [Change] of Display Brightness.
3 Press [1] - [4] (Darker- Lighter) to adjust brightness.
4 Press [OK].
Silent Mode
Make the machine run more quietly. Select this mode when the running noise is uncomfortable.
Use the procedure below to set Silent mode.
1 Press the System Menu key.
2 Press [ ], [Adjustment/Maintenance] and then [Change] of Silent Mode.
3 Press [Off] or [On].
4 Press [OK].
NOTE: When [On] is selected, preparation for the next printing may take longer.
Auto Color Correction
This setting allows you to adjust the detection level used by the machine to determine whether the original is
color or black and white in Auto Color Selection Mode. Setting a lower value will result in more originals being
identified as color, while a larger value will tend to increase the number of originals being identified as black and
white.
Use the procedure below to set the Auto Color Detection Level.
1 Press the System Menu key.
2 Press [ ], [Adjustment/Maintenance], [ ] and then [Change] of Auto Color Correction.
3 Press one of keys [1] to [5] (Color - B & W) to set the detection level.
4 Press [OK].
Tone Curve Adjustment
Makes the grayscale of the printed image more consistent with the original. Perform calibration before using tone
curve adjustment. If you find that the grayscale is not improved by Calibration (see page 9-74), use tone curve
adjustment.
NOTE: To perform tone curve adjustment, verify that either Letter or A4 paper is loaded into a cassette.
A total of 2 pattern pages (No. 1 and 2) are printed during adjustment. The printed patterns are read sequentially
during the adjustment.