PLANET ADN-4101 - Manual (Page 16)

802.11n Wireless ADSL2/2+ Router
ADN-4101
Chapter 2. Hardware Installation
Step 1 Connect the LINE interface of the device and the Modem interface of the splitter with a telephone cable.
Connect the phone set to the Phone interface of the splitter through a telephone cable. Connect the input
cable to the Line interface of the splitter.
The splitter has three interfaces:
Line: Connect to a wall phone interface (RJ-11 jack).
Modem: Connect to the LINE interface of the device.
Phone: Connect to a telephone set.
Step 2 Connect the LAN interface of the device to the network card of the PC through an Ethernet cable
(MDI/MDIX).
Use the twisted-pair cable to connect the hub or switch.
Step 3 Insert one end of the power adapter to the wall outlet and connect the other end to the POWER interface of
the device.
The following figure shows the application diagram for the connection of the router, PC, splitter and the telephone
sets.
11