PLANET ADN-4101 - Manual (Page 23)

802.11n Wireless ADSL2/2+ Router
ADN-4101
After setting, click Next and the page as shown in the following figure appears.
The following table describes the parameters on this page:
Field Description
Obtain an IP address automatically
Select it, DHCP automatically assigns the IP address for WAN
connection.
Use the following IP address
When selecting it, you need to manually enter the IP address,
subnet mask, and default gateway for WAN connection, which are
provided by your ISP.
Obtain DNS server addresses
automatically Select it, DHCP automatically assigns DNS server address.
Use the following DNS server
addresses Select it, you need to manually enter the primary DNS server
address and secondary DNS server address.
Enable NAT
Select it to enable network address translation (NAT). If you do not
select it and you want to access the Internet normally, you must
add a route on the uplink equipment. Otherwise, the access to the
Internet fails. Normally, it is required to enable NAT.
For subsequent configuration, refer to the description in the above section PPPoE/PPPoA.
If the WAN connection type is set to 1483 Routed, the parameters of the WAN
connection type are the same as that of 1483 MER. For the parameters on these
pages, refer to the parameter description of 1483 MER.
18