PLANET ADN-4101 - Manual (Page 53)

802.11n Wireless ADSL2/2+ Router
ADN-4101
3.5.6 ACL
Choose Service > ACL and the page shown in the following figure appears. On this page, you can permit the data
packets from LAN or WAN to access the router. You can configure the IP address for Access Control List (ACL). If
ACL is enabled, only the effective IP address in the ACL can access the router.
If you select Enable in ACL capability, ensure that your host IP address is in ACL list
before it takes effect.
The following table describes the parameters and buttons on this page:
Field Description
Direction Select
Select the router interface. You can select LAN or WAN. In this example, LAN
is selected.
LAN ACL Switch Select it to enable or disable ACL function.
IP Address
Enter the IP address of the specified interface. Only the IP address that is in
the same network segment with the IP address of the specified interface can
access the router.
Services Allowed
You can choose the following services from LAN: Web, Telnet, SSH, FTP,
TFTP, SNMP, or PING. You can also choose all the services.
Add After setting the parameters, click it to add an entry to the Current ACL Table.
Reset Click it to refresh this page.
Set direction of the data packets to WAN and the page shown in the following figure appears.
48