PLANET ADN-4101 - Manual (Page 21)

802.11n Wireless ADSL2/2+ Router
ADN-4101
The following table describes the parameters on this page:
Field Description
PPP Username Enter the username for PPPoE dial-up, which is provided by your ISP.
PPP Password Enter the password for PPPoE dial-up, which is provided by your ISP.
PPP Connection Type
You can select Continuous, Connect on Demand, or Manual.
Continuous: After dial-up is successful, PPPoE connection is always on-line,
no matter whether the data is being transmitted or not. It is recommended to select
it.
Connect on Demand: After dial-up is successful, within the preset idle time,
no data is being transmitted, and the router automatically disconnects the PPPoE
connection.
In this case, you need to enter the idle time.
Manual: Select it, you need to dial up and disconnect the connection
mannually.
After setting, click Next and the page as shown in the following figure appears.
The following table describes the parameters on this page:
Field Description
LAN Interface Setup
LAN IP
Enter the IP address of LAN interface. Its valid value is in the range of
192.168.1.1 to 192.168.255.254. The default IP address is 192.168.1.1.
LAN Netmask
Enter the subnet mask of LAN interface. Its valid value is in the range of
255.255.0.0 to 255.255.255.254.
Enable Secondary IP
Select the checkbox to enable the secondary LAN IP. The two LAN IP
addresses must be in the different network.
DHCP Server
Enable DHCP Server
Select the checkbox to enable DHCP server.
Start IP Enter the start IP address that the DHCP sever assigns.
End IP Enter the end IP address that the DHCP server assigns.
Max Lease Time The lease time determines the period that the PCs retain the assigned IP
16