PLANET ADN-4101 - Manual (Page 57)

802.11n Wireless ADSL2/2+ Router
ADN-4101
The following describes how to configure manual DMZ.
Step 1 Select Enable DMZ to enable this function.
Step 2 Enter an IP address of the DMZ host.
Step 3 Click Apply Changes to save the settings on this page temporarily.
3.6.2.2 Virtual Server
Click Virtual Server in the left pane and the page shown in the following figure appears.
The following table describes the parameters on this page.
Field Description
Service Type
You can select the common service type, for example, AUTH, DNS or FTP. You
can also define a service name.
If you select Usual Service Name, the corresponding parameter has the
default settings.
If you select User-defined Service Name, you need to enter the
corresponding parameters.
Protocol
Choose the transport layer protocol that the service type uses. You can choose
TCP or UDP.
WAN Setting You can choose Interface or IP Address.
WAN Interface Choose the WAN interface that will apply virtual server.
WAN Port Choose the access port on the WAN.
LAN Open Port Enter the port number of the specified service type.
LAN IP Address
Enter the IP address of the virtual server. It is in the same network segment with
LAN IP address of the router.
3.6.2.3 NAT Forwarding
Click NAT Forwarding in the left pane and the page shown in the following figure appears. Under 1483MER or
1483Routed mode, if NAPT (Network Address Port Translation) is enabled, the Local IP Address is configured as
192.168.1.3 and the Remote IP Address is configured as 202.32.0.2, the PC with the LAN IP192.168.1.3 will use
202.32.0.2 when it is connected to the Internet via the router without NAPT control.
52