PLANET ADN-4101 - Manual (Page 34)

802.11n Wireless ADSL2/2+ Router
ADN-4101
29
Field Description
Delete Selected Select a row in the DHCP Static IP Table, then click it, this row is deleted.
Reset Click it to refresh this page.
DHCP Static IP Table It shows the assigned IP address based on the MAC address.
3.4.2 WAN
Choose Network > WAN and the WAN page that is displayed contains WAN, Auto PVC, ATM Settings and ADSL
Settings.
3.4.2.1 WAN
Click WAN in the left pane and the page shown in the following figure appears. On this page, you can configure WAN
interface of your router.
The following table describes the parameters on this page:
Field Description
Default Route Selection You can select Auto or Specified.
VPI
The virtual path between two points in an ATM network, ranging
from 0 to 255.
VCI
The virtual channel between two points in an ATM network, ranging
from 32 to 65535 (1 to 31 are reserved for known protocols)
Encapsulation You can choose LLC and VC-Mux.
Channel Mode
You can choose 1483 Bridged, 1483 MER, PPPoE, PPPoA, 1483
Routed or IPoA.
Enable NAPT
Select it to enable Network Address Port Translation (NAPT)
function. If you do not select it and you want to access the Internet
normally, you must add a route on the uplink equipment. Otherwise,
the access to the Internet fails. Normally, it is enabled.
Enable IGMP You can enable or disable Internet Group Management Protocol