ProSoft Technology MVI46-103M - Manual (Page 53)

Diagnostics and Troubleshooting MVI46-103M ♦ SLC Platform
IEC 60870-5-103 Master Communication Module
ProSoft Technology, Inc. Page 53 of 187
September 12, 2006
Tip: Repeat this command at one-second intervals to determine the frequency
of program execution.
Exiting the Program
Caution: Some of the commands available to you from this menu are
designed for advanced debugging and system testing only, and can cause the
module to stop communicating with the processor or with other devices,
resulting in potential data loss or other failures. Only use these commands if
you are specifically directed to do so by ProSoft Technology, Inc. Technical
Support staff. Some of these command keys are not listed on the menu, but
are active nevertheless. Please be careful when pressing keys so that you do
not accidentally execute an unwanted command.
Press [Esc] to exit the program and display the operating system prompt. This
command will cause the module to cease operation and stop transferring data
between the ports and the module, and between the processor and the module.
This could interrupt a currently running process. Only use this command if
instructed to do so by the ProSoft Technical Support Group.
Warm Booting the Module
Caution: Some of the commands available to you from this menu are
designed for advanced debugging and system testing only, and can cause the
module to stop communicating with the processor or with other devices,
resulting in potential data loss or other failures. Only use these commands if
you are specifically directed to do so by ProSoft Technology, Inc. Technical
Support staff. Some of these command keys are not listed on the menu, but
are active nevertheless. Please be careful when pressing keys so that you do
not accidentally execute an unwanted command.
Press [W] from the Main Menu to warm boot (restart) the module. This command
will cause the program to exit and reload, refreshing configuration parameters
that must be set on program initialization. Only use this command if you must
force the module to re-boot.