ProSoft Technology MVI46-103M - Manual (Page 82)

MVI46-103M ♦ SLC Platform Reference
IEC 60870-5-103 Master Communication Module
Page 82 of 187 ProSoft Technology, Inc.
September 12, 2006
Error Description
902 Negative COT in response
903 Session is offline
904 Session is disabled
905 Select confirmation received, waiting to execute
906 Execute confirmation has not be received
7.4 MVI46-103M Configuration Data Definition
This section contains a listing of the parameters and their definitions for the
MVI46-103M module configuration file definition (IEC103M.CFG).
7.4.1 MVI46 IEC 60870-5-103 Master Communication
Module Configuration
[Section]/Item Value Range Description
[Backplane Configuration] Backplane transfer parameters
Module Name: 0 to 80
characters This parameter assigns a name to the
module that can be viewed using the
configuration/debug port. It can be used to
identify the module and the configuration
file.
Failure Flag Count: 0 to 65535 This parameter specifies the number of
successive transfer errors that must occur
before the communication ports are shut
down. If the parameter is set to 0, the
communication ports will continue to
operate under all conditions. If the value is
set larger than 0 (1-65535),
communications will cease if the specified
number of failures occur.
Pass-Through Events: Y or N This parameter specifies if event messages
received on the master ports will be passed
to the processor. If the parameter is set to
N, event messages will not be passed to
the processor. If the parameter is set to Y,
the module will pass all events received to
the processor using block identifier 9903.
[Section]/Item Value Range Description
[IEC 60870-5-103 MASTER] Module level parameters
Session Count: 1 to 32 This parameter specifies the maximum
number of session to establish on the
module. This corresponds to the number of
slaves to be interfaced with the module.
This value represents the total number of
slaves on both ports combined.