HP 20-Feb User Manual
Page 102
100 Configuring the Library
Chapter 3
Note
The MAC address is unique to each remote management card
and is used for identification. This address cannot be configured.
To successfully use BOOTP from the library, your system
administrator must first configure the BOOTP server using the
5. Enter the IP Address.
Use the
[+]
key to change the number.
Use the
[
->
]
key to move to the next number.
Use the
[Down]
key to move to the next address.
6. Enter the subnet mask using the same procedure.
7. Enter the gateway address.
8. Press
[OK]
when complete to save the changes, or press
[Quit]
to exit the
menu and not save the changes. A message will display to confirm the
changes you have entered or alert you if the changes have not been
saved.
9. Enter the designated IP address into the web browser to launch the Web-
Based Library Administrator pages.
Example 1 - All modes (Manual, DHCP, or BOOTP):
IP address = 15.28.33.12
http://15.28.33.12
Example 2 - Manual and BOOTP only:
Device name = library1
http://library1
Note
To use a device name, your system administrator must add the
device name you select to the domain name server (DNS).
Note
Instructions and online help screens describing remote
management are available from the Web-Based Library
Administrator pages by selecting the
[?]
button in the top right-
hand corner of any page.