HP 20-Feb - Manual (Page 37)

Chapter 1 Connecting and Powering on the Library 35
Cha
pter 1
6. Connect a category 5 ethernet cable from the remote management card to
an active network port (see Using the Remote Management Card on
page 96).
Note The AC power cord is the library’s main AC disconnect device
and must be easily accessible at all times.
7. For 2/20, 4/40, and 6/60 Series Libraries:
— Connect a power cord to each power supply module on all levels.
For 8/80 and 10/100 Series Libraries:
— Connect the power cords on the rack to a power outlet on each
library level.
— Connect the power cord from the power distribution unit to a
dedicated, grounded power receptacle.
8. Power on the library. The power (standby) switch is recessed and on the
lowest level on the front of the library.
After the power-up test is complete (after several minutes), you will see the
Home Screen on the library's front panel. The Home Screen displays the
status of the drives and library. See Front Panel Overview on page 60.
9. Power on other peripherals, and then the host.