HP 20-Feb - Manual (Page 94)

92 Configuring the Library Chapter 3
Enabling and Changing the Password
Note Administration procedures can be password protected. These
procedures include: diagnostic tests, configurations, online drive
repair, and setting the date and time. A password is also
required for administration through the remote management
card.
When the library is first installed, the password is inactive. To protect the
system from unauthorized access, use the following procedure to set a
password.
1. Enter
the Password menu. A status screen will indicate if a password is
enabled.
— If the password is turned off, select
Set New Password to enable the
password.
— If the password is turned on, select Change Password to enter the new
password. It must be exactly eight digits.
— If the password is turned on, select Turn Password Off to clear the
password.
Note If you enter more than eight digits, the ninth digit will become
the first digit of the new password.
2. Select [OK] to exit.
Caution Be sure to document the password. If you forget the password,
contact your service representative.
Main Menu -> Administration -> Change Configuration -> Password