HP 20-Feb - Manual (Page 108)

106 Setting SCSI IDs Chapter 3
Setting SCSI IDs
Note This menu is unavailable for libraries using Fibre Channel
because the SCSI IDs are configured automatically.
Note Each device on the same SCSI bus must have its own unique
SCSI ID. SCSI ID 7 is not used as the default for drive position 7
because it is typically used by the host computer.
Main Menu -> Administration -> Change Configuration -> SCSI IDs
Table 15 Default SCSI IDs
Device
a SCSI ID
Library controller 0
Drive position 1 1
Drive position 2 2
Drive position 3 3
Drive position 4 4
Drive position 5 5
Drive position 6 6
Drive position 7 8
Drive position 8 9
Drive position 9 10
Drive position 10 11
a.The number of drives depends on the library model.