MITSUBISHI ELECTRIC MR-J2S- CL - Manual (Page 36)

1 - 17
1. FUNCTIONS AND CONFIGURATION
(4) MR-J2S-700CL
POINT
The servo amplifier is shown without the front cover. For removal of the
front cover, refer to next page.
MODE UP DOWN SET
MODE UP DOWN SET
Name/Application Reference
Battery connector (CON1)
Used to connect the battery for absolute position data
backup.
Section4.5
Battery holder
Contains the battery for absolute position data backup.
Section4.5
Display
The 5-digit, seven-segment LED shows the servo
status and alarm number.
Chapter7
Operation section
Used to perform status display, diagnostic, alarm and
parameter setting operations.
Chapter7
Used to set data.
Used to change the
display or data in each
mode.
Used to change the
mode.
I/O signal connector (CN1A)
Used to connect digital I/O signals.
Section3.3
I/O signal connector (CN1B)
Used to connect digital I/O signals.
Section3.3
Communication connector (CN3)
Used to connect a command device (RS-422/RS232C)
and output analog monitor data. Chapter6
Chapter15
Section14.1.4
Charge lamp
Lit to indicate that the main circuit is charged.
While this lamp is lit, do not reconnect the cables.
Control circuit terminal block (TE2)
Used to connect the control circuit power supply.
Encoder connector (CN2)
Connector for connection of the servo motor encoder.
Name plate
Main circuit terminal block (TE1)
Used to connect the input power supply, regenerative
brake option and servo motor.
Protective earth (PE) terminal ( )
Ground terminal.
Section3.7.2
Section14.1.4
Section3.3
Section14.1.4
Section1.3
Section3.7.2
Section12.1
Section14.1.1
Section3.10
Section12.1 Cooling fan
Installation notch
(4 places)