SATO HT200e User Manual
Page 109
SECTION 6: ON LINE
Page 6-4
SATO HT200e
2.
Data regulating print position
This command specifies value that regulates print position.
<M>
･
[ 1B (H), 4D (H) ] nnn
････
n (32 bytes can be designated.)
E
S
C
M
Designation
for vertical
size of paper
Designa-
tion for
horizontal
size of
paper
Type
of
paper
Regulation of
vertical
position
Regulation of
horizontal
position
Name of
format
Name of
label
1
2
3
4
5
6
7
8
9
10
11
12 13
to
22 23
to
32
Digit
position
Item
Description
1 to 3
Designation for vertical size of
paper
It is displayed in “mm”.
4 to 5
Designation for horizontal size of
paper
It is displayed in “mm”.
6
Type of paper
It can select from the following:
1: NORMAL (Non-gap label for HT200e)
2: OPTION (M32 label)
7
Regulation of vertical position
(Direction)
It designates direction that can be fine adjusted for print.
Value; 1:+, 0: -
8 to 9
Regulation of vertical position
(Volume of migration)
It designates unit for dot in numbers. 1 dot = 0.025mm
10
Regulation of horizontal position
(Direction)
It designates direction that can be fine adjusted for print.
Value; 1: +, 0: -
11 to 12
Regulation of horizontal position
(Volume of migration)
It designates unit for dot in numbers. 1 dot = 0.025mm
13 to 22
Name of format
It specifies name of each format.
23 to 32
Name of label
It specifies name of label for each format.
[Direction that print position can be controlled]
Di
re
ction of
pa
pe
r to
be forwarded
Up to 5mm or 40 dots in all directions can be
controlled. Note: Some position of print may
vary the number of dot that is adjustable.
Ver. -
Hori.
-
+
+