SATO HT200e - Manual (Page 96)

SECTION 5 ： PRESET, TABLE DATA
Page 5-4 SATO HT200e
PRINTING OF PRESET DATA
[RCL]
[ENTR]
[ENTR]
[ENTR]
[ENTR]
[ENTR]
Note: Where asterisk mark or “*” can be seen in the upper right on the screen, entry by scanner
can be made possible.
Ｆ Ｏ Ｒ Ｍ Ａ Ｔ Ｎ ｏ
1 ［ ・ ・ ］
Ｈ Ｔ ２ ０ ０ ｅ
［ Ｐ Ｒ Ｅ Ｓ Ｅ Ｔ ］
2 Ｐ Ｒ Ｉ Ｎ Ｔ Ｓ Ｔ Ｒ Ｍ Ｏ Ｄ Ｉ Ｆ Ｙ
Ｄ Ｅ Ｌ Ｄ Ｕ Ｍ Ｐ Ｍ Ａ Ｓ Ｔ Ｅ Ｒ
Ｐ Ｒ Ｅ Ｓ Ｅ Ｔ Ｎ Ｏ ． Ｉ Ｎ Ｐ Ｕ Ｔ ＊
3 ・ ・ ・ ・ ＜ Ｐ Ｒ Ｉ Ｎ Ｔ ＞
［ Ｉ Ｔ Ｅ Ｍ ］
4 ・ ・ ・ ・ ・ ・ ・ ・ ・
［ Ｐ Ｒ Ｉ Ｃ Ｅ ］
5 ￡ ・ ・ ・ ・ ・ ・
［ Ｑ Ｔ Ｙ ］
6 ・ ・ ・ ・
Ｐ Ｒ Ｉ Ｎ Ｔ Ｉ Ｎ Ｇ
7
Press [RCL], so that it goes from the modes of the
print to the preset.
The screen for the selection of preset printing will
be displayed: Press [ENTR], so that it goes to the
entry of preset number.
The preset No. that is required to print can be
entered: Press [ENTR], so that it displays the pre-
set data specified.
Since the contents of data differ, based on the
format number retrieved, press [ENTR] by
checking data in each field.
Enter the No. of paper within 4 digits, and press
[ENTR]. Note that neither 0 nor un-entry is
permitted.
Preset will start printing:
Note: where the No. of print becomes 0, it goes
back to the process No. 3.