SATO HT200e - Manual (Page 15)

SECTION 1 SPECIFICATION
SATO HT200e Page 1-1
SECTION 1: SPECIFICATION
SPECIFICATION
PRINT
Model HT200e
Print Method Direct Thermal
Printer module 0.125 mm (0.0049")
Resolution 203 dpi (8dpmm)
Speed
60 or 80 mm/s (2.4"/s or 3.1"/s)
*60mm/s when used with battery
Print Area (Max) 48mm (1.89") W x 96mm (3.78”) L
MEDIA
Normal
Width 25.4 ～ 48.0 mm (0.98" ～ 1.89")
Width (Backing Paper size) 28.0 ～ 51.0 mm (1.10" ～ 2.01")
Pitch 13.0 ～ 100.0 mm (0.51" ～ 3.94")
Pitch (Backing Paper size) 16.0 ～ 103.0 mm (0.63" ～ 4.06")
Caliper 0.14 ～ 0.19mm (Thickness)
Dispense
Width 25.4 ～ 48.0 mm (0.98" ～ 1.89")
Width (Backing Paper size) 28.0 ～ 51.0 mm (1.10" ～ 2.01")
Pitch 25.4 ～ 48.0 mm (0.98" ～ 1.89")
Pitch (Backing Paper size) 25.4 ～ 50.0 mm (0.98" ～ 1.96")
Caliper 0.14 ～ 0.19mm (00055" ～ 0.0075")
Roll Outer diameter (MAX) 75mm (2.95")
Core Inner diameter (Min) 26.5mm (1.1")
Wind Face-In or Face-Out
PRINTER
Sensor type Reflective sensor for use with pre-printed sensing eye-marks
Operational Panel Switch
FNC1, FNC2, FMT, PGUP, RCL. AC, 0 ～ 9,
SHIF, SET, FEEDS/S, ENTR, DEL, DATE, #, $!"
Self Diagnosis Checking Cover open, Paper end, Head check, Test print, Battery check