SATO HT200e - Manual (Page 26)

SECTION 2: INSTALLATION AND SETUP
Page 2-8 SATO HT200e
INSTALLING OPTION
INSTALLING THE MEMORY CARD
To register the preset data, you can use the PC card.
How to set the PC card
IMPORTANT !!
Before using a new PC card, clear it.
1.
Turn off the main unit power.
2.
Open the card slot cover in the upward direction on the
right side of the main unit, and insert the PC card in it.
With the "
△" marked side of the PC card facing upward,
insert it in the illustrated direction.
IMPORTANT !!
If you force the card into position by reversing the direction,
the main body of the card and main unit connector may be
damaged.
Sufficient care must be taken to prevent it.
Remove the PC card
1.
Press the Ejector button on the right side of the slot.
2.
The PC card will be ejected slightly, so pull out the PC
card.
• Before inserting or removing the PC card, be sure to
turn off power of the printer main unit otherwise, the
PC card, circuit board or main printer may be dam-
aged.
• If the PC card is not set, keep the card cover closed to
prevent entry of foreign substances.