SATO HT200e - Manual (Page 6)

II SATO HT200e
Danger
PUT the printer on a flat surface
If it is placed on an unstable plane, it may drop or f
l all causing injury.
KEEP AWAY from container containing liquid.
Do not place printer near container of water or chemical. Should liquid
spilled or soaked into printer, turn off the power immediately and pull out the
plug from the outlet. Do Not use this device it may cause fire or electric shock.
Contact your dealer , sales reprentative or service center for assistants. i
DO NOT INSERT foreign matter into printer
Metals and flammable material should not be inserted into printer openings
such as cable outlets or memory card slot. Should these material be accidentally
inserted , turn off power and pull out the plug from the power point immediately.
Contact your dealer,sales representative or nearest service center. Do not use
the device as it may cause fire , lectric shock or unsuspected problem.
USE voltage that is only specified:
AC100V - 220V is only allowed for the use of a printer. If
NOT, it may cause a fire
or electric shock.
How to Handle a Power Code:
- Any flaw, crack, or damage as a result of overload to the printer, overheat,
cord-pulling, or any other process may cause a fire or electric shock.
- When any wear on the electric cord , such as bared core wire and wire-
breaking, are to be found, contact a dealer, sales representative, or service
center.
DO NOT USE the device as it may cause a fire, electric shock, or
unsuspected problem.
-
NO machining or any intentional bending, twisting, or pulling (additional ten-
sion) is ALLOWED. If printer in a defective state is remained used, it may cause
a fire or electric shock.