SATO HT200e - Manual (Page 24)

SECTION 2: INSTALLATION AND SETUP
Page 2-6 SATO HT200e
CHARGING BATTERY PACK
The output voltage of the battery pack is reduced as it is being used.
Reduced output voltage will lead to reduction in the number of labels to be issued, or will disable
the label to be issued.
The battery must be charged if the following screen appears when the power of this equipment
has turned on or during issue of labels.
Screen indicating the remaining battery power.
• The battery is fully charged.
• Charge the battery. It is getting flat.
• To start printing, charge the battery.
(The buzzer will sound for several seconds, and power will be
turned off automatically in several minutes.)
1.
Turn off the power of the main unit.
2.
Remove the battery pack from the main unit.
*To remove it, push the lock of the battery pack, and slide it
towards you.
3.
Prepare the battery charger (optional)
*Insert the battery charger DC plug into the main unit of the
battery charger.
*Insert the battery charger power plug into the outlet.
4.
Set the battery pack to the battery charger.
*When the battery pack is set, the battery charger lamp will light up in red.
*Charging time is about 150 minutes when fully charged, though it may
vary according to battery conditions.
When charging is completed, the lamp will light up in green.
IMPORTANT !!
If the battery charger lamp flashes on and off in red during charging, the battery pack is faulty.
Stop charging and replace the battery pack with a new one.
BATTERY FULL
CHARGE PWR PACK
PRINT BATT LOW