SATO HT200e - Manual (Page 23)

SECTION 2: INSTALLATION AND SETUP
SATO HT200e Page 2-5
BATTERY PACK CONNECTION
If you want to use the printer where no wall outlet is available, connect the optional battery pack.
IMPORTANT !!
*1. Charge the battery pack before using it for the first time.
*2. After following this procedure, set the power type on the "Battery" in the initial setting step.
1. Set the battery pack to the groove of the Main Unit.
2. Insert it by sliding forward until you hear it click.
*To remove it, push the lock of the battery pack
down and slide it towards you.
3. Turn on the power switch.
The power to be used must be set on the "Battery"
in the initial setting step.
*This printer has a function that power is automatically
turned off if operation is not performed for five
minutes or more after the power-switch is turned on
(Auto Power Off Function). This function must be set
to minimize battery consumption.
CAUTION ABOUT BATTERY PACK
When you do not use this equipment for a long time, charge it once or twice every 3 months. This
will minimize battery consumption.
When you do not use this equipment, be sure to turn off the switch. This will minimize battery
consumption.
The battery can be used at the normal temperature by repeating charging about 300 times. After
repeating charging about 300 times, the label will not be issued or the number of label s issued
will be reduced. In this case replace by a new one.
The number of labels issued will be changed according to charging or temperature. When the
equipment is used at the normal temperature, the number of labels issued will be about
4000(5rolls) in the case of labels with are 25mm(pitch) x32mm (width).