SATO HT200e - Manual (Page 123)

SECTION 7: OTHERS
SATO HT200e Page 7-3
SCREEN ON SEQUENTIAL PARAMETER SETTING
Where, in the 17th digit of the sequential number field, value other than “0” is entered, sequential
number will become valid. Press [FNC1], so that it goes to the screen for the entry of sequential
number parameter.
Example)If, for the last 3 digits in a total of 6 digits, “2” is specified as additional data (value) and
2 copies are required to be printed:
Note 1: From 0, subtraction can not be made. So “0” will be printed in this case.
If, for the sequence No. with addition, “9” is arrayed in all digits and “1” is specified as an
additional data, the number except the positive number (as below) will be printed as the
result of calculation.
9 9 9 9 + 1 ->1 0 0 0 0 ( “0000” will only be printed. )
Note 2: Should data be fixed, count will be started from the value.
If “0” is the result of the calculation for all digits based on specified subtraction, “0” will be
printed in all digits.
Ｓ Ｅ Ｑ Ｕ Ｅ Ｎ Ｃ Ｅ Ｔ Ａ Ｂ Ｌ Ｅ
１ : ＋ Ｉ Ｎ Ｃ ２ : － Ｄ Ｅ Ｃ
０ ０ ０ ０ ０ ０ ０ ０ ０ ０
Ｓ Ｅ Ｑ Ｕ Ｅ Ｎ Ｃ Ｅ Ｔ Ａ Ｂ Ｌ Ｅ
１ : ＋ Ｉ Ｎ Ｃ ２ : － Ｄ Ｅ Ｃ
１ ０ ４ ３ ０ ０ ２ ０ ０ ２
Identical No. of copy to
sequential number
Addition: 1; Subtraction: 2
Starting position
No. of digit: 1 to 8
Addition/subtraction
Enter value, and press [ENTR] so that it returns to the
screen before registration. Where [PGUP] is pressed, it
goes back to the previous screen without registration.
Whereas [SHFT] is pressed, guidance will be dis-
played.
Set value not exceeding a total of 32 digits that are the
sum of starting position and digit.
Value ranging from 1 to 9 can be registered for TABLE.
Note: Where out-of-specified data are entered and
[PGUP] is pressed, data entered will be cleared.
Sample number:
123001
123001
123003
123003
123005
123005
･
･
2 copies for the same arrangement
Additional data and sequence No.: 1
Starting position: from the 4th
No. of digits: 3
“2” as a value for addition