Smeg SCM1 User Manual

Page 80

Advertising
background image

80

6 - MANUTENZIONE

I

6 - MANTENANCE

GB

CB1607-260

F

CB1607-270

CB1607-280

2

6.5

Sostituzione della guarnizione portafiltro

• Accedere nella parte interna della macchina, come descritto nel paragrafo

“APERTURA SUPERIORE”.

• Localizzare il portafiltro

F. (Fig.35)

• Rimuovere la guarnizione OR portafiltro danneggiata aiutandosi, se

necessario, con un cacciavite a lama piatta.

• Pulire la sede della guarnizione con il pennellino

2.

• Posizionare la nuova guarnizione, senza usare alcun utensile.

6.6

Sostituzione della lampada

• Controllare che l’interruttore generale della macchina sia spento.

• Scollegare la macchina dalla presa di corrente.

• Svitare la plafoniera della lampada nel punto indicato in figura 36 (a destra

del beccuccio erogazione caffè).

• Svitare la lampadina e sostituirla con una nuova e della stessa tipologia

(2W).

• Riposizionare la plafoniera.

ATTENZIONE! Superfici calde.

Alcune parti della macchina, possono trovarsi ad una tem-

peratura molto alta e provocare ustioni! Accertarsi che la

macchina sia fredda.

IMPORTANTE!

QUESTA OPERAZIONE DEVE ESSERE ESEGUITA OGNI 6

MESI

SG-065

35

36

6.5

How to replace the filter holder gasket

• For access inside the machine, follow the instructions in paragr. “HOW

TO OPEN THE TOP OF THE MACHINE”.

• Find the filter holder

F. (Fig.35)

• If necessary, use a flat-bladed screw driver to remove the filter holder OR

gasket.

• Clean the gasket slot with the brush

2.

• Put a new gasket into position without the aid of any tool.

6.6

How to replace the light bulb

• Check that the main switch of the machine is switched off.

• Disconnect the machine from the mains plug.

• Unscrew the lamp cover at the point shown in the picture 36 (to the right

of the coffee spout).

• Unscrew the light bulb and replace it with a new one of the same type

(2W).

• Replace the cover into position.

WARNING! Hot surfaces.

Some parts of the machine become extremely hot and can

burn! Make sure the machine has cooled down.

IMPORTANT!

THIS OPERATION MUST BE PERFORMED EVERY 6
MONTHS

Advertising