Symbol Technologies AP-5131 - Manual (Page 100)

AP-5131 Access Point Product Reference Guide 4-24
2. Configure the SNMP Access Control screen to add the IP addresses of those users receiving
SNMP access.
Access Control List Enter Start IP and End IP addresses (numerical addresses only, no
DNS names supported) to specify a range of user that can access
the
AP-5131 SNMP interface. An SNMP-capable client can be set
up whereby only the administrator (for example) can use a read/
write community definition.
Use just the Starting IP Address column to specify a single SNMP
user. Use both the Starting IP Address and Ending IP Address
columns to specify a range of addresses for SNMP users.
To add a single IP address to the ACL, enter the same IP address in
the Start IP and End IP fields.
Leave the ACL blank to allow access to the SNMP interface from
the IP addresses of all authorized users.
Add Click Add to create a new ACL entry.
Edit Click Edit to revise an existing ACL entry.
Delete Click Delete to remove a selected ACL entry for one or more SNMP
users.