Symbol Technologies AP-5131 - Manual (Page 559)

AP-5131 Usage Scenarios B-13
19. On AP-5131 #2/ Device #2, repeat the same procedure. However, replace AP-5131 #2
information with AP-5131 #1 information.
20. Once both tunnels are established, ping each side of the tunnel to ensure connectivity.
B.2.2 Configuring a Cisco VPN Device
This section includes general instructions for configuring a Cisco PIX Firewall 506 series device.
For the usage scenario described in this section, you will require the following:
• 1 Cisco VPN device
• 1 PC connected to the LAN side of the AP-5131and the Cisco PIX.
Below is how the AP-5131 VPN Status screen should look if the entire configuration is setup correctly
once the VPN tunnel is active. The status field should display "ACTIVE".
NOTE The Cisco PIX device configuration should match the AP-5131 VPN
configuration in terms of Local WAN IP (PIX WAN), Remote WAN
Gateway (AP-5131 WAN IP), Remote Subnet (AP-5131 LAN Subnet), and
the Remote Subnet Mask. The Auto Key Settings and the IKE Settings on
the Cisco PIX should match the AP-5131 Key and IKE settings.