Symbol Technologies AP-5131 - Manual (Page 214)

AP-5131 Access Point Product Reference Guide 6-28
6.10.1 Configuring LAN to WAN Access
The AP-5131 LAN can be configured to communicate with the WAN side of the AP-5131. Use the
Subnet Access screen to allow/deny access to the AP-5131 WAN protocols, specify names and
properties for existing protocols and enable pre-configured protocols (FTP, TFTP, Telnet ect.).
To configure AP-5131 subnet access:
1. Select Network Configuration -> Firewall -> Subnet Access from the AP-5131 menu
tree.
2. Refer to the Overview table to view rectangles representing subnet associations. The three
possible colors indicate the current access level, as defined, for each subnet association.
Color Access Type Description
Green Full Access No protocol exceptions (rules) are specified. All traffic may
pass between these two areas.
Yellow Limited Access One or more protocol rules are specified. Specific protocols
are either enabled or disabled between these two areas.
Click the table cell of interest and look at the exceptions
area in the lower half of the screen to determine the
protocols that are either allowed or denied.
Red No Access All protocols are denied, without exception. No traffic will
pass between these two areas.