Sun Microsystems Sun Fire X4100 - Manual (Page 112)

3-52 Sun Fire X4100 and Sun Fire X4200 Servers Service Manual • June 2006
FIGURE 3-45 Opening a PCI Card Latch
c. Pull the PCI card out of the PCI riser. Ensure that the PCI card’s rear connector
panel is released from the tab on the chassis rear panel.
7. Remove the Graphics Redirect and Service Processor (GRASP) board:
a. Disconnect any external cables from the GRASP board’s connectors.
b. Squeeze the plastic standoff that protrudes through the GRASP board to press
the standoff’s locking tabs. See FIGURE 3-46 .
If you have difficulty pressing the locking tabs with your fingers, you can use a
pair of thin-nosed pliers.