Sun Microsystems Sun Fire X4100 - Manual (Page 121)

Chapter 3 Maintaining the Sun Fire X4100 Server 3-61
The system designation and the speeds of the two PCI slots are shown in FIGURE 3-57 .
The slots for the PCI cards are detected by the system BIOS during bootup in the
order described in
Section 2.3.2.1, “PCI Card Slot Booting Priority” on page 2-5 .
Note – Before you install a card, consult the manufacturer’s documentation for
system requirements and configuration information for your specific PCI card.
FIGURE 3-57 Sun Fire X4100 Designation and Speeds of PCI Slots
5. Remove any existing PCI card from the slot, or go to Step 6 if the slot is empty:
a. Disconnect any external cables that are attached to the PCI card.
b. Working from the rear of the chassis, pivot the PCI card latch for the slot
upward. See FIGURE 3-58 .
FT1
FM0 FT1
FM1 FT1
FM2
FT0
FM0 FT0
FM1 FT0
FM2
CPU1 CPU0
Front panel of server
Back panel of server
PCIX1
(133 MHz) PCIX0
(100 MHz)