Sun Microsystems Sun Fire X4100 - Manual (Page 199)

Chapter 4 Maintaining the Sun Fire X4200 Server 4-69
FIGURE 4-65 Removing the Upper Cable Retainer
9. Remove the flex cable and its attached foam rubber gasket from the chassis
midwall by disconnecting the cable’s four connectors from the following four
locations. See
FIGURE 4-66 .
1. DVD-ROM drive
2. Hard disk drive backplane
3. Power distribution board
4. Motherboard
Note – When reinstalling the flex cable, attach the connector to the power
distribution board (3) first. Then attach the remaining three connectors in any order.