Sun Microsystems Sun Fire X4100 - Manual (Page 154)

4-24 Sun Fire X4100 and Sun Fire X4200 Servers Service Manual • June 2006
11. Replace the front bezel to the chassis:
a. Align the pegs on the rear of the bezel with the corresponding holes in the
front of the chassis.
Note – Ensure that the new DVD-slot faceplate is over the DVD-ROM drive and
that the button on the DVD-slot faceplate is oriented toward the chassis bottom. See
FIGURE 4-1 .
b. Press the bezel evenly against the front of the chassis until it is flat against the
front of the chassis.
c. Open the fan bay door on the front cover and tighten the captive retaining
screw that secures the bezel in place. See FIGURE 4-3 .
12. Replace the main cover to the chassis:
a. Set the cover in place so that it aligns with the keyed openings in the chassis
sides.
b. Slide the cover toward the chassis front until it is firmly and squarely against
the edge of the front cover.
13. Return power to the server. See Section 2.1, “Powering On the Server” on page 2-2 .