Sun Microsystems Sun Fire X4100 User Manual
Page 177
Chapter 4
Maintaining the Sun Fire X4200 Server
4-47
12. Unfasten the five screws that secure the HDD backplane to the rear of the drive
bays. See
13. Remove the HDD backplane from the chassis.
FIGURE 4-42
Removing the HDD Backplane
Installation is the reverse of this procedure.
Note –
When you replace the HDDs to their bays, you must return each HDD to the
bay from which it was removed. If the HDDs were previously configured as a
mirrored RAID 1 array, an automatic resynchronization is invoked with no need to
reconfigure the RAID parameters. Any hot-spares are automatically reconfigured as
hot-spares in the configuration.
Note –
When you reinstall a HDD, open its securing latch before you push the drive
into the bay. Push the HDD into the bay until it stops, then close the securing latch
to fully engage the connector on the HDD backplane.