Figure 3-34 – Sun Microsystems Sun Fire X4100 User Manual
Page 98
Advertising
3-38
Sun Fire X4100 and Sun Fire X4200 Servers Service Manual • June 2006
FIGURE 3-34
Removing the GRASP Board
5. Raise the corner of the GRASP board until it is clear of the locking tab.
6. Pivot the front edge of the GRASP board upward to disengage it from the rear
plastic bracket and to disengage its connector from the motherboard.
Note –
Be careful to avoid bending the GRASP board while removing or installing
it.
Installation is the reverse of this procedure.
Power status LED CR1
Advertising