Primera Technology Fujitsu Tape Drive RX300 S2 - Manual (Page 103)

103
PRIMERGY RX300 S2 User’s Guide
3
O
S
In
st
allation
U
sing ServerS
ta
rt
■ Checking Remote Resources
Check that the remote resource server is shared properly.
1
Start up "Command Prompt" on the remote resource server. Enter the following
and press the [Enter] key.
prompt:>net share
Check that the created shared folder is displayed properly.
For the net command, refer to Windows Help.
■ Starting Installation
Start installation from the target server.
●
In Guided Mode / Expert Mode
1
Turn on the server and insert the ServerStart CD-ROM immediately.
ServerStart starts up and a message appears prompting you to insert the ServerStart floppy disk.
2
Create a ServerStart floppy disk.
When the ServerStart floppy disk supplied with the server is used
1. Insert the ServerStart floppy disk supplied with the server. Make sure that
"Removable media" and "A:" are selected and click [Create].
The network startup setting window for remote installation appears.
2. Click [OK].
The [Initialization of ServerStart core running] window appears and unattended installation
will be started. Depending on the hardware configuration, this process may take a few
minutes. When the process is completed, the [Create a ServerStart Floppy Disk] window
appears.
3. Click [Build a ServerStart Floppy Disk].
Creation of a ServerStart floppy disk starts. When the creation is completed, the "Floppy
disk has been created." message appears.
When the remote floppy is used
1. Select "Remote (media)" and click [OK].
The [Network Startup Setting] window for remote installation appears.
2. Click [OK].
The [Specify Drive] window appears.
3. Enter [Remote path], [User name], and [Password] and click [OK].
The [Initialization of ServerStart core running] window appears and unattended installation
will be started. Depending on the hardware configuration, this process may take a few
minutes. When the process is completed, the [Welcome to ServerStart] window appears.
3
Click [Click here to prepare and/or initiate an operating system installation].
The [Select the operating system to be installed] window appears.
Click [Special Hints on Operating System Installation] and read the contents. Important
information such as limitations on disk configuration is described.