Primera Technology Fujitsu Tape Drive RX300 S2 - Manual (Page 44)

44
Chapter 2 Checking before OS Installation
Connecting to the Internet during setup can cause security problems. Do not connect to the Internet
until the setup completes.
2.1.2 Hardware Settings
Before starting installation, set necessary hardware, such as the BIOS Setup Utility.
■ BIOS Setup Utility
The BIOS Setup Utility must be set in the following cases. For details on how to set the BIOS Setup
Utility, refer to "8.2 BIOS Setup Utility" ( pg.223).
●
Changing the Boot Drive
To change the boot drive, start up the BIOS Setup Utility, select [Boot Option], and set the boot drive.
"8.2.4 Boot Options Submenu" (pg.228)
●
Performing Remote Installation
Before performing remote installation of ServerStart, use the following procedures to enable network
startup (PXE). In addition, check the MAC address.
1
Take the following steps in the BIOS Setup Utility.
1. Start the BIOS Setup Utility.
"8.2.1 Starting and Exiting the BIOS Setup Utility" (pg.223)
2. Select [Boot Options] and press the [Enter] key.
The Boot Options menu window appears.
3. Change [MultiBoot for HDs] to [Enabled].
4. Press the [Esc] key and select the [Advanced] menu.
5. Select the [Peripheral Configuration] submenu and change [LAN Remote Boot
Ch.A] to [PXE].
"8.2.6 Peripheral Configuration Submenu" (pg.231)
6. Press the [Esc] key. Select [Save Changes & Exit] from the [Exit] menu to exit the
BIOS Setup Utility.
7. Start the BIOS Setup Utility again.
8. Select the [Boot Option] submenu from the [Main] menu. Press the [Enter] key.
The Boot Option submenu window appears.
9. Change the [Boot Sequence] setting as shown below.
10. Exit the BIOS Setup Utility and turn off the server.
1 BootManage PXE, Slot 0500
2 CD-ROM
3 Removable Device
4 Hard Drive