Primera Technology Fujitsu Tape Drive RX300 S2 - Manual (Page 120)

120
Chapter 4 Manual OS Installation
● Before Starting Operation
After OS installation, refer to the following and perform the necessary procedures.
• Installation of high reliability tools
To ensure stable server operation, refer to "Chapter 6 High Reliability Tools" ( pg.167) and install
high reliability tools.
• "Chapter 5 Operations after OS Installation" ( pg.129)
Perform the necessary procedures.
4.2.2 Installing Windows 2000 Server
1
Create driver disks.
Prepare necessary drivers before installing Windows 2000 Server.
Some drivers used with Windows 2000 Server are created from the ServerStart CD-ROM. For
how to create driver disks, refer to "4.1 Creating Driver Disks" ( pg.112).
2
Insert the Windows 2000 Server CD-ROM.
Turn on the server and insert the Windows 2000 Server CD-ROM immediately into the CD-ROM
drive. Check there are no floppy disks in the floppy disk drive. When the active area is specified
on the hard disk, the following message appears.
Pressing any key while this message is displayed boots the system from the CD-ROM.
3
The [Windows 2000 Server Setup] window appears.
Immediately, the following message appears at the bottom of the window. Press the [F6] key.
This message will be displayed for a short time after the setup window (blue screen) appears.
Press the [F6] key immediately after the window turns blue.
4
Install the drivers manually.
1. When the following message appears, press the [S] key.
Press any key to boot from CD....
Press F6 if you need to install a third party SCSI or RAID
driver ...
To specify additional SCSI adapters, CD-ROM drives,
or special disk controllers for use with Windows
2000,including those for which you have a device
support disk from a mass storage device
manufacturer, press S.