Primera Technology Fujitsu Tape Drive RX300 S2 - Manual (Page 108)

108
Chapter 3 OS Installation Using ServerStart
Settings values in wizards
Setting items in wizards are set to the values set on the first server. For installation on subse-
quent servers, you must change the following items in the "OS installation wizard". For other
items, change the setting as necessary. You do not need to start up wizards where no settings
will be changed.
If the settings for the first server are not reflected to wizards, perform the procedure over again
from copying the floppy disk.
3.5.3 Installation in Preconfiguration Mode
Edit the configuration file and perform installation in preconfiguration mode.
If ServerStart is not installed in the client computer where the preconfiguration mode is executed, refer
to "2.4 Preparation for Using ServerStart on a Client Computer" ( pg.52) to install ServerStart. If a
different version of ServerStart has been installed, uninstall it and install the proper version. For details
on how to uninstall ServerStart, refer to "2.4.2 Uninstalling ServerStart" ( pg.54).
ServerStart starts up when it is installed. However, be sure to follow these installation procedures.
"3.2.1 Starting Up the Preconfiguration Mode" ( pg.73) Performing the procedure deletes the contents
of the ServerStart floppy disk, making the disk unavailable for installation on multiple servers.
1
Start up ServerStart.
If ServerStart has already been started, it is not necessary to restart it. If it has not, start it up
according to the following procedures.
When the CD has been copied on Windows 2000 Professional/Windows XP
Professional
1. Click [Start]
→ [Programs] → [Fujitsu ServerStart] → [ServerStart].
ServerStart starts up and the [Welcome to ServerStart] window appears.
When Windows NT is used, or if the CD has not been copied
1. Insert the ServerStart CD-ROM into the client computer's CD-ROM drive.
ServerStart starts up and the [Welcome to ServerStart] window appears.
2
Select the OS to be installed.
The preconfiguration mode starts up.
table: Settings to be Changed for Installation on Subsequent Servers
Window
name
Setting item name Remarks
User
Information Computer name The setting must be changed when the second
and subsequent servers are on the same
network as the first server.
Product ID/CD key The setting must be changed.
Network
Protocol IP address The setting must be changed when the second
and subsequent servers are on the same
network as the first server.