Primera Technology Fujitsu Tape Drive RX300 S2 - Manual (Page 17)

17
PRIMERGY RX300 S2 User’s Guide
1
Overview
●
Configuration File (SerStartBatch.ini)
A configuration file stores the server setup and client information configured in ServerStart. To create a
configuration file, use the ServerStart floppy disk supplied with this server. Store only one file on each
floppy disk. Do not set the ServerStart floppy disk to the write-protected state.
You can use any name for the configuration file. However, the file must be installed in the server as
"SerStartBatch.ini". When installing the file, make sure to save it as "SerStartBatch.ini" on the
ServerStart floppy disk.
Start up ServerStart, insert the ServerStart floppy disk containing "SerStartBatch.ini", and click [Start] to
install the server.
■ Intuitive User Interface
The intuitive user interface allows you to easily set the necessary information.
●
Main Window
When ServerStart is started, the following window appears.
The window and tool bar differ depending on the mode.