Primera Technology Fujitsu Tape Drive RX300 S2 - Manual (Page 157)

157
PRIMERGY RX300 S2 User’s Guide
5
Operatio
ns
after O
S
In
st
al
lation
4
Select an adapter to add to the created team from [Available adapters], click
the [ ] and [ ] buttons, and move the adapter to [Load Balance member]
or [Standby member].
When adding adapter "[0005] Broadcom NetXreme Gigabit Ethernet", the following message
appears but click [Yes (Y)] and go to the next step. "[0005] Broadcom NetXreme Gigabit Ether-
net" (port LAN A) is connected to BMC (micro controller for server management) and can con-
trol power supply and other functions via a LAN. When a team is created, communication
function with BMC is not inherited to other adapters.
5
Click [Apply] to apply the settings.
After the network is temporarily disconnected, a window is displayed. Click [Yes (Y)].
When continuing to VLAN settings, go to "5.6.3 VLAN Setup Procedure" ( pg.158).