Primera Technology Fujitsu Tape Drive RX300 S2 - Manual (Page 73)

73
PRIMERGY RX300 S2 User’s Guide
3
O
S
In
st
allation
U
sing ServerS
ta
rt
3.2 Preconfiguration Mode
In preconfiguration mode, set and save the information necessary for installation in a
configuration file on a client computer (with a CD-ROM drive and 10MB or more of
free space). Set the saved configuration file on the server for installation.
If ServerStart is not installed in the client computer where the preconfiguration mode is executed, refer
to "2.4 Preparation for Using ServerStart on a Client Computer" ( pg.52) to install ServerStart. If a
different version of ServerStart has been installed, uninstall it and install the proper version. For details
on how to uninstall ServerStart, refer to "2.4.2 Uninstalling ServerStart" ( pg.54).
If ServerStart is started up on a computer where a different version of ServerStart is installed, the
installation wizard may not operate properly. Make sure to uninstall a different version of ServerStart.
3.2.1 Starting Up the Preconfiguration Mode
Start up the preconfiguration mode.
1
Start up ServerStart.
If ServerStart has already been started, it is not necessary to start it up again. If it has not, start it
up according to the following procedures:
When the CD has been copied Windows 2000 Professional/Windows XP
Professional
1. Click [Start]
→ [Programs] → [Fujitsu ServerStart] → [ServerStart].
ServerStart starts up and the [Welcome to ServerStart] window appears.
When Windows NT is used, or if the CD has not been copied
1. Insert the ServerStart CD-ROM into the client computer's CD-ROM drive.
ServerStart starts up and the [Welcome to ServerStart] window appears.